SAFETY PRECAUTIONS
Before using or handling this lubricant, consult the latest Safety Data Sheet (SDS) for complete health, safety, handling, storage, and environmental information.
Handling
- Avoid prolonged or repeated skin contact.
- Avoid contact with eyes.
- Do not ingest the product.
- Use only in well-ventilated areas.
Personal Protective Equipment (PPE)
- Wear suitable protective gloves when handling new or used lubricant.
- Use safety glasses or eye protection where splashing may occur.
- Wash hands thoroughly after handling.
Storage
- Store in the original, tightly closed container.
- Keep in a cool, dry, and well-ventilated area.
- Protect from direct sunlight, excessive heat, and ignition sources.
- Prevent contamination from water, dust, and other foreign materials.
Spill Response
- Contain spills promptly with suitable absorbent material.
- Prevent product from entering drains, waterways, or soil.
- Dispose of contaminated absorbents in accordance with local regulations.
Disposal
- Dispose of used oil, empty containers, and contaminated materials through authorized waste management facilities.
- Do not discharge product into sewers, surface water, or the environment.
KEY FEATURES
| ✓ Strong extreme pressure (EP) performance |
✓ Effective protection against wear |
| ✓ Good oxidation stability |
✓ Corrosion protection |
| ✓ Foam control for consistent lubrication |
✓ Reliable performance in heavy-duty service |
TYPICAL CHARACTERISTICS
| Property |
Test Method |
Unit |
Typical Value |
| Density @ 15°C |
ASTM D4052 |
g/ml |
0.881 |
| Kinematic Viscosity @ 40°C |
ASTM D445 |
mm²/s |
72 |
| Kinematic Viscosity @ 100°C |
ASTM D445 |
mm²/s |
9.2 |
| Viscosity Index |
ASTM D2270 |
– |
103 |
| Acid Number (AN) |
ASTM D974 |
mg KOH/g |
0.38 |
| Pour Point |
ASTM D6892 |
°C |
-24 |
| Flash Point (COC) |
ASTM D92 |
°C |
225 |
| FZG Gear Test, Fail Stage |
DIN 51354 |
Stage |
12 |
DISCLAIMER
The information in this Technical Data Sheet is based on typical characteristics and is intended as a guide for product selection and application. Specifications may be updated as part of continuous improvement programs. Confirm suitability with the equipment manufacturer and consult the latest SDS before use.
